MC-35225PE SORBET #16-1620 TPG MC-35227PE MERLOT #17-1723 TPG MC-35228PE SANGRIA #19-1863 TPG

MC-17637PE MIST #12-5204 TPG MC-17638PE HORIZON #15-4005 TPG MC-17644PE CHICORY #16-4132 TPG

MC-24929PE JADE #16-6127 TPG MC-24930PE KIWI #15-0545 TPG MC-24931PE CELERY #13-0442 TPG

PRNewswire/ -- 5G technology will provide the backbone for a step-change in performance of mobile devices, allowing ultrafast download speeds and the ability to connect billions of devices through a network.  In particular, the IoT (Internet of Things) will be made much more powerful with 5G, as increased connectivity will allow real-time changes to power and resource needs.  for broadband, including equipment that enables and expands access to high-speed communications throughout the country.

FLAMINGO 17-1937-TPG PAPAYA 16-1450-TPG AZURE 16-4529- TPG

The graphics, documents, and articles contained on this World Wide Web (www) site and Avient sites elsewhere on the Internet are the copyrighted work of Avient Corporation and contain proprietary trademarks and trade names of the company, its subsidiaries, and joint ventures. The articles, information and works provided in this World Wide Web site and Avient Corporation sites elsewhere on the Internet are provided "AS IS," WITHOUT ANY WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, NONINFRINGEMENT, OR OTHERWISE.

Typical screw speeds range from 50 - 150 rpm. Injection Speed A worn or contaminated check ring can limit the machine's ability to hold pressure and maintain a cushion.

In addition, 5G makes cities smarter and opens up new possibilities in remote health care and the internet of things (IoT). Learn more about Avient's formulations for 5G that lead to accelerated speed to market, design flexibility, and high heat resistance

Typical screw speeds range from 50 - 150 rpm. Injection Speed A worn or contaminated check ring can limit the machine's ability to hold pressure and maintain a cushion.

BASE RESIN ABS Drying Temperature 80–90°C Drying Time 2–3 Hours Barrel Temperatures °C Rear Zone 180–210 Center Zone 190–220 Front Zone 200–230 Nozzle 210–240 Mold Temperature 50–80 Screw Speed Moderate Back Pressure 3–10 bar Cushion 5–15 mm Injection Speed Low to medium Injection Pressure Moderate to high Holding Pressure 10–30% of injection pressure Screw Type General purpose Screw L/D 20:1 Screw Compression Ratio 2.0:1–2.5:1 Non-return Check Valve Free flow check ring Nozzle Type Reverse taper Barrel Capacity 30–80% of barrel should be used STARTUP & SHUTDOWN RECOMMENDATIONS Purge Compound 2–3 melt flow PP or purging compound. Incomplete Fill Melt and/or mold temperature too cold • Increase nozzle and barrel temperatures • Check thermocouples and heater bands Shot size • Increase shot size • Adjust transfer position to 98% full • Increase cushion • Enlarge or widen vents and increase number of vents • Check that vents are unplugged • Check that gates are unplugged • Enlarge gates and/or runners • Perform short shots to determine fill pattern and verify proper vent location • Increase wall thickness to move gas trap to parting line Brittleness Degraded/overheated material • Decrease melt temperature • Decrease back pressure • Use smaller barrel Gate location and/or size • Relocate gate to non-stress area • Increase gate size to allow higher flow rate and lower molded-in stress Wet material • Check moisture. Fibers on Surface (Splay) Melt temperature too low • Increase injection speed Wet material • Check moisture.