It then freezes after pack and hold and acts as a plug. However, a gate needs to be large enough to provide good packing. In relation, if the hold/pack time is too long, the runner will be packed out, which could cause processing problems

EXTRUDER Screw 3/4" to 6" Polyethylene type—Single flight, no mixing section, 1.5–2:1 compression ratio Tooling Semi-Pressure type: 30°–40° angle Die On size with 1/8" or less land L/D 24:1 recommended Screen Pack No screen pack (Optional depending on pressure) Cooling Trough 120–150°F (50–65°C) recommended Feeder Gravimetric type preferred—3 compartment for cross-linked Dryer Desiccant type, 4 hours at 160°F (70°C) For ECCOH™ compound only; never put Dry Silane in Dryers PROCESSING Temperature ECCOH 5000 Series ECCOH 6000 Series Wire Preheat 180–250°F (80–120°C) 180–250°F (80–120°C) Feed Zones 200°F (93°C) 275°F (135°C) Transition 275°F (135°C) 325°F (163°C) Metering 300°F (150°C) 375°F (190°C) Head/Die 330°F (165°C) 420°F (215°C) Target Melt 330–340°F (165–170°C) 420–440°F (215–225°C) Flame at Die Tip Yes—as needed Line Speed Shear sensitive: Observe Melt Temperature, Motor Amperage, and Pressure Purge Compound HDPE Copyright © 2020, Avient Corporation.

It then freezes after pack and hold and acts as a plug. However, a gate needs to be large enough to provide good packing. In relation, if the hold/pack time is too long, the runner will be packed out, which could cause processing problems

Lightweighting for the “Pack It In, Pack It Out” Enthusiast When every ounce counts and energy conservation is key, you want to make equipment that is as light as possible but strong and reliable. Help them customize with materials that fit a wide variety of needs—from colors and patterns to textures and soft touch materials—and keep you ahead of the pack

Colorant Chromatics FEP UV Laser Marking Product Bulletin_CN8.29-1

Pressure - This part of the equation is usually caused by over stacking hot garments at the oven or packing them immediately into boxes. Certain things cannot be controlled by the printer: • The dye in the shirt • The humidity in the air and shirt Things that can be controlled are: • The type of ink – cotton white for cotton, non-ghosting bleed resistant for polyester • The amount of heat used on the garment—cure at the recommended temp, not over • Stack in separate piles to allow cooling—fold in dozens separately, wait to pack Be aware of at-risk colors; brown, tan and beige are the most sensitive to possible ghosting.

FlexCart Nano is the ideal metering system for smaller throughputs and uses a standard 1kg PlanetPak™ container as the delivery pack. This includes a single point level monitoring system to indicate when a delivery pack change is required.

Since the FlexCart Micro has a smaller footprint for use in operations where space is limited, the metering system uses the smaller 10L (LN) polymer delivery pack. The FlexCart Micro unit, due to its smaller footprint and reduced throughput range, is designed to work with the LN molded polymer containers—specifically the 10-liter pack.

Low pack pressures. Low pack pressures. Reduce pack pressure